DETERMINATION OF POLYCYCLIC AROMATIC HYDROCARBONS IN SOIL SAMPLES AROUND SELECTED ABUAD POWER GENERATORS

DETERMINATION OF POLYCYCLIC AROMATIC HYDROCARBONS IN SOIL SAMPLES AROUND SELECTED ABUAD POWER GENERATORS

ABSTRACT

This work covers the determination of PAHs in soil samples around selected ABUAD

power generators. The PAHs in the soil samples where extracted in the laboratory using

Soxhlet extraction method. Samples where finally concentrated and analyzed using Gas

Chromatography and Mass Spectrometry (GC-MS).

The total concentration of PAHs in sample one was 10.6186g/g and in sample 2 was

18.9826g/g. Naphthalene had the highest concentration in sample 1, it was

2.1016g/g. Naphthalene, -methyl had the highest concentration in sample 2, it was

7.9991g/g

Indene, octahydro had the lowest concentration in sample 1, it was 8.8861g/g. Indene,

-dihydro- -dimethyl had the lowest concentration in sample 2, it was 0.366g/g.

It could be assumed that the main source of PAHs in these soil samples analysed are

were processes related to fossil fuel combustion.

CHAPTER ONE

INTRODUCTION

1.1 Background of Study

Polycyclic Aromatic Hydrocarbons refers to a large class of organic compounds

which contains two or more fused aromatic rings made up of carbon and hydrogen

atoms. PAHs have the following general characteristics common to them; high melting

and boiling points, low vapour pressure and very low water solubility which tends to

decrease with increasing molecular mass (Ahland and Mertens, 1980). Most of the

PAHs with low vapour pressure in the air are adsorbed on particles. When dissolved in

water or adsorbed on particulate matter, PAHs can undergo photodecomposition when

exposed to ultraviolet light from solar radiation. In the atmosphere, PAHs can react

with pollutants such as ozone, nitrogen oxides and sulfur dioxide, yielding diones, nitroand

dinitro-PAHs, and sulfonic acids, respectively. PAHs may also be degraded by

some microorganisms in the soil (WHO, 1987; USDHHS, 1994).

PAHs are important priority organic pollutants. They may be released during

incomplete combustion or pyrolysis of organic matter. This is a major source of human

exposure. PAHs emanate primarily as combustion products from vehicle and generator

emissions, coal and oil burning plants. They are conveyed by rainfall into the aquatic

environment after being absorbed onto smoke particles settling in all kinds of surfaces.

(Brookes and Lawley, 1964).

Toxicological studies have shown that some of these PAHs have the potential

for tetratogenesis or carcinogenesis in human beings. As a result of their highly

hazardous nature, they are monitored in waste waters, soils and atmosphere. Sensitive

detection and accurate reproducible quantification of organics is very important in

minimizing the health risks of PAHs. (Larsson, 1982).

PAHs are formed mainly as a result of pyrolytic processes, especially the

incomplete combustion of organic materials during industrial and other human

activities, such as processing of coal and crude oil, combustion of natural gas, including

for heating, combustion of refuse, vehicle traffic, cooking and tobacco smoking, as well

as in natural processes such as carbonization. There are several hundred PAHs; the best

known is benzo[a]pyrene (BaP). In addition a number of heterocyclic aromatic

compounds (e.g. carbazole and acridine), as well as nitro-PAHs, can be generated by

incomplete combustion (WHO, 1987).

The emissions of BaP into the air from several sources in the Federal Republic

of Germany in 1981 were estimated to amount to 18 tonnes: about 30% was caused by

coke production, 56% by heating with coal, 13% by motor vehicles and less than 0.5%

by the combustion of heating oil and coal-fired power generation. Other BaP sources

were not taken into consideration (WHO, 1987). However, the present contributions

from the different important sources, such as residential heating (coal, wood, oil),

vehicle exhausts, industrial power generation, incinerators, the production of coal tar,

coke and asphalt, and petroleum catalytic cracking, are very difficult to estimate. These

figures may also vary considerably from country to country. In the USA, the residential

burning of wood is now regarded as the largest source of PAHs (USDHHS, 1994).

Stationary sources account for a high percentage of total annual PAH emissions.

However, in urban or suburban areas, mobile sources are additional major contributors

to PAH release to the atmosphere (Baek et al., 1991).

Atmospheric PAHs are continuously deposited to the earth by dry or wet

deposition processes. Some of these PAHs are from nearby sources, such as automotive

or generators exhaust. Other PAHs are from more distant sources and have been carried

various distances through the air. About 500 PAHs and related compounds have been

detected in the air, but most measurements have been made on BaP. Data obtained prior

to the mid-1970s may not be comparable with later data because of different sampling

and analytical procedures (WHO, 1987). The natural background level of BaP may be

nearly zero. In the USA in the 1970s, the annual average value of BaP in urban areas

without coke ovens was less than 1 ng/m3 and in other cities between 1 and 5 ng/m3. In

several European cities in the 1960s, the annual average concentration of BaP was

higher than 100 ng/m3 (WHO, 1987). In most developed countries BaP concentrations

have decreased substantially in the last 30 years. Thus PAH levels lower by a factor of

5 to 10 than those in 1976 were reported for a traffic tunnel in Baltimore and for ambient

air in London in the second half of the 1980s (Baek et al., 1991). The declines were

attributed to the increased use of catalytic converters in motor vehicles, a reduction in

coal and open burning with a movement to oil and natural gas as energy sources, and

improved combustion technology. PAH emissions from open burning, especially coal,

have been declining in many developed countries as a result of efforts to control smoke

emissions (Baek et al., 1991). In 1990, a German study found BaP concentrations of

below 1 ng/m3 at monitoring stations not affected by emission sources, from 1.77–3.15

ng/m3 at stations close to traffic, and 2.88–4.19 ng/m3 at stations with traffic and

additional industrial emission sources. The annual (1989-1990) average concentration

of BaP close to traffic in the Rhine-Ruhr area was reported to be 3–6 ng/m3 (Pfeffer,

1994). In Copenhagen, the mean BaP concentration (January to March 1992) at a station

in a busy street was found to be 4.4 ng/m3 (Nielsen et al., 1995).

Additional contributions from tobacco smoking and the use of unvented heating

sources can increase PAH concentrations in indoor air and, in certain cases, PAHs can

increase to very high levels indoors (Mumford et al., 1991 and Maroni et al., 1995).

BaP levels of 14.7 μg/m3 were found in Chinese (Xuan Wei) homes burning smoky

coal (Mumford et al., 1987). In India, the BaP concentration was reported to average

about 4 μg/m3 during cooking with biomass fuel (WHO, 1987). Very high

concentrations of BaP can occur in workplaces. Measurements using stationary

samplers or personal samplers over an 8-hour period showed average BaP

concentrations of between 22 and 37 μg/m3 on the topside of older coke oven batteries

and between 1 and 5 μg/m3 at several other worksites in the same plants. High values

have also been reported in the retort-houses of coal-gas works in the United Kingdom,

ranging from 3 μg/m3 in mask samples to more than 2 mg/m3 in peak emissions from

the retorts. In the aluminum-smelting industry, concentrations much higher than 10

μg/m3 were found at some workplaces (WHO, 1987).

1.2 Statement of Problem

Atmospheric PAHs are continuously deposited to the soil by dry or wet

deposition processes. Some of these PAHs are from nearby sources, such as generator

exhaust. The atmosphere is the most important means of PAH dispersal, it receives the

bulk of the PAHs environmental load resulting in PAHs being ubiquitous in the

environment. PAHs are emitted to the atmosphere primarily from the incomplete

combustion of organic matter. The combustion sources can be either natural or

anthropogenic. The natural sources include volcanoes and forest fires. While the

anthropogenic sources are vehicle exhaust, agricultural fires, power plants, coke plants,

steel plants, foundries and other industrial sources. PAHs tend to be found in greater

concentrations in urban environments than in rural environments because most PAH

sources are located in or near urban centers. Once released to the atmosphere, PAHs

are found in two separate phases, a vapor phase and a solid phase in which the PAHs

are sorbet onto particulate matter (Ravindra et al., 2008; Wang et al., 2013; Zhang and

Tao, 2009). Hydrophobic organic chemicals with low vapor pressures, such as PAHs,

are sorbet to atmospheric particulates more readily than chemicals with higher vapor of

different PAH compounds cause the individual PAHs to distribute in different

concentrations in the vapor (Kameda, 2011) and other sorbet phases (Kuo et al., 2012).

PAHs can be added to soils if fill materials contain PAHs. When PAHs are

deposited onto the earth’s surface, they can become mobile. Since the majority of PAHs

in the soil will be bound to soil particles (Masih and Teneja, 2006; Cachada et al., 2012),

the most important factors influencing PAH mobility of particulates in the subsurface

will be sorbent particle size and the pore throat size of the soils. Such pore throat can

be defined as the smallest opening found between individual grains of soil (Riccardi et

al., 2013). If particles to which PAHs are sorbet cannot move through the soil then the

movement of PAHs will be limited because they tend to remain sorbet to particles.

17 PAHs have been identified as being of greatest concern with regard to

potential exposure and adverse health effects on humans and are thus considered as a

group. The International Agency for Research on Cancer (IARC, 2010) classifies some

PAHs as known, possibly, or probably carcinogenic to humans (Group 1, 2A or 2B).

Among these are benzo[a]pyrene (Group 1), naphthalene, chrysene, benz[a] anthracene,

benzo[k]fluoranthene and benzo[b]fluoranthene (Group 2B) (IARC, 2010). Some

PAHs are well known as carcinogens, mutagens, and teratogens and therefore pose a

serious threat to the health and the well-being of humans. The most significant health

effect to be expected from inhalation exposure to PAHs is an excess risk of lung cancer

(Kim et al., 2013).

1.3 Aim and Objectives

The research aim and objectives are:

1.3.1. Aim

The aim of this study is to quantify the concentrations of Polycyclic Aromatic

Hydrocarbons (PAHs) in soil samples collected around selected ABUAD power

generators.

1.3.2. Objectives

The specific objectives are to:

i. extract PAHs from soil samples collected around selected ABUAD

generators using Soxhlet extraction method.

ii. determine the concentration of PAHs from (i)

iii. identify control measures for PAHs deposition in soil

TOPIC: DETERMINATION OF POLYCYCLIC AROMATIC HYDROCARBONS IN SOIL SAMPLES AROUND SELECTED ABUAD POWER GENERATORS

Chapters: 1 - 5
Delivery: Email

Number of Pages: 68

Price: 3000 NGN

In Stock

Buy the Complete Material Now